1) What is the correct PPE to be worn when carrying a battery.
Safety Boots, coveralls, gloves, safety goggles
2) When charging a battery what are the five things you should do.
Battery off the ground, keep away from metal, use a trickle charger, stable platform as not to spill it
3) What is the correct procedure to removing a starter motor.
Remove battery terminals, remove wires from the starter motor. remove the 2 bolts holding the SM to the flywheel.
4) Three components used to check a battery.
Volt meter, Hydrometer, Load Tester.
5) What is a short circuit.
A short circuit is when a source of high resistance finds a path to ground of low resistance causing a spark.
6) What is a parallel circuit.
A parallel circuit is when a source of power splits into two or more paths before joining back together.
7) When the car is running at idle, what voltage should be read on the alternator.
14.5V
8) If the battery warning light is not working, what does this mean for the alternator.
The light is complete on the alternator. this is to give it a little start to charge and keep it going.
9) What is the purpose of a relay.
A relay is like a switch which receives a low current signal and open the pathway for a high current source to be complete.
10) What is Volts and Amps.
Volts is the strength of the electrical charge and Amps is the amount of charge going through the circuit.
11) When using a multimeter, how should you connect in volts and amps.
Volts should be connected in parallel with the components or wires, Amps should be in series with components.
12) When checking a battery, what are the SOP.
accidentally shorting the battery. Keep the terminals clear, use the voltmeter and use each prong on the terminal.
13) What is the difference between the Alternator belts.
V belt and Poly-V belt.
14) First two stages of a Starter Motor.
When you turn the key the bendix engages pulling the lever, pushing the wheel out onto the flywheel. the second stage then engages and spins the wheel which turns the flywheel turning the motor over.
15) What is an Alternator and what is a starter motor.
An Alternator charges the battery and a starter motor only starts the battery then its job is done.
16) What is the difference between the two.
The alternator contains copper inside with magnets spinning on the inside using the belt. This creates a magnetic field, this charges the battery. The starter just spins the flywheel.
17) What is the acid inside the battery.
Sulfuric acid
18) What is the 3 main numbers in the electrical module.
30 positive 31 ground 15 ignition
19) What is voltage drop and how is it tested.
voltage drop is when there is a significant drop in voltage across a wire or component. Use a voltmeter to check between battery 12.6V to the component which might be 6V
20) What component in the ALT converts AC to DC.
The rectifier pack
good answers 18/20
ReplyDelete